Adjusting-Telescoping-Pole; Power-Connection; Power-Circuit-Breaker; Connecting-Extension-Cord - IKRA THS 500 Manuel D'utilisation

1.- Push-the-round-button-located-on-the-side-of-the-pivot-
bracket.-The-button-is-spring-loaded,-so-you-will-feel-
some-resistance-when-pulling-it-out.
2.- Grasp-the-power-head-motor-housing-and-rotate-the-
power-head-to-either-of-the-6-positions.
3.- Release-the-round-button.-
It-should-snap-back-into-its-seated-position.-If-it-does-not,-
rotate-the-power-head-back-and-forth-slightly-until-the-but-
ton-snaps-back-into-its-seated-position.-The-power-head-
is-now-locked-into-position-and-ready-for-use.
WARNING: To- guard- against- injury- observe- the-
following:
•- Read- instruction- manual- before- using,- save- instruc-
tion-manual.
•- Keep-hands-away-from-blade.
•- Keep-hands-on-handles.-Don't-overreach.
•- A-good,-firm-grip-on-the-Pole-Trimmer-with-both-hands-
will- help- you- maintain- control.- Don't- let- go.- Grip- the-
rear-handle-with-your-right-hand-whether-you-are-right-
or-left-handed.-Wrap-the-fingers-of-your-left-hand-over-
and-around-the-front-handle.
Adjusting telescoping pole
Disconnect the pole trimmer from the power
supply.
Rotate-the-collar-(1)-counter-clockwise-( )-to-loosen.
Push-poles-towards-each-other-to-shorten-the-pole-or-pull-
away-from-each-to-lengthen-the-pole.
Note: Extend-the-pole-only-to-the-length-required-to-reach-
the-cut-hedges-or-shrubs.-
When-the-desired-length-is-achieved,-rotate-the-collar-(1)- -
clockwise-( )-to-secure.
Power connection
The-machine-can-only-be-connected-to-a-singlephase-a.c.-
current-connection.The-machine-is-protectively-insulated-
in-accordance-with-classification-II-of-VDE-0740.--Before-
using-the-machine-ensure-that-the-mains-current-agrees-
with-the-operating-voltage-data-on-the-machine's-identi-
fication-plate.
Power circuit breaker
We- recommend- to- operate- the- pole- trimmer- in- connec-
tion-with-a-residual-current-operated-device-with-a-maxi-
mum-breaking-current-of-30mA.
Connecting Extension Cord
The- Pole-Trimmer- has- a- built-in- extension- cord- retainer-
to- prevent- the- accidental- disconnection- of- the- unit- from-
the-extension-cord-during-use.-It-is-molded-into-the-lower-
hand-guard-area-of-the-trigger-housing.
1.- Make-sure-the-trigger-lever-is-in-the-OFF-position-
2.- Plug-the-power-cord-into-the-extension-cord.
3.- Create- a- loop- in- the- extension- cord- and- insert- the-
loop-through-the-bottom-of-the-handle.-Pull-the-loop-
tight-around-the-molded-cord-hook.
GB-10