GE GTH21 Série Manuel D'utilisation Et D'installation page 22

REVERSING THE DOOR SWING
REMOVE FREEZER DOOR
1
Tape the door shut with masking tape.
Remove the hinge cover on top of the freezer door.
Remove the four screws with a 5/16" socket and
ratchet, then lift the hinge straight up to free the
hinge pin from the socket in the top of the door.
Top Hinge
Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
NOTE: Do not misplace the washer located on the top
side of the center hinge pin.
Set the door on a non-scratching surface with
the inside up.
REMOVE REFRIGERATOR DOOR
2
Tape the door shut with masking tape.
Remove the center hinge by removing two hinge
screws with a 5/16" socket and ratchet. Lift the
hinge pin up and out of the door.
NOTE: Do not misplace the washer located on the
underside of the center hinge pin.
Plastic Washer
Hinge Pin
Center Hinge
Bracket
Fresh Food Door
Remove the tape and tilt the door away from the
cabinet. Lift the door straight up to free its bottom
socket from the pin in the bottom hinge bracket.
Set the door on a non-scratching surface with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
Installation Instructions
22
(CONT.)
TRANSFER TOP HINGE TO
3
THE LEFT
Interchange hinge and screws at top right with screws
at the top left of cabinet.
Do not tighten screws on hinge side at this time.
TRANSFER BOTTOM HINGE
4
BRACKET TO THE LEFT
For models with a base grille, remove it by grasping it
about 6" from each end and pulling its bottom edge
toward you.
Using a 5/16" socket and ratchet, remove the 3 screws
from the bottom hinge. Taking care not to misplace
the washer on the bottom hinge, move the bottom
hinge from the right to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the door.
Replace the base grille by inserting the tops of the
metal clips into the oval vents, making sure one of the
plastic tabs on the back of the grille goes into each of
the oval vents. Then push the bottom of the grille
forward until it snaps into place.
Plastic
Washer
Hinge Bracket