JVC KD-A735BT Manuel D'instructions page 15

Masquer les pouces Voir aussi pour KD-A735BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 Perform (A) or (B) depending on what scrolls on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below
(A) If "[Device Name]" "XXXXXX"
"VOL – YES" "BACK – NO" scrolls on the
display,
"XXXXXX" is a 6-digit passkey randomly
generated during each pairing.
Ensure that the passkey which appears
on the unit and Bluetooth device is the
same.
Select "YES" to confirm the passkey.
Operate the Bluetooth device to confirm
the passkey.
After pairing is successful, "PAIRING COMPLETED" appears on the display.
The unit will establish a connection with the newly paired Bluetooth device, " " lights up on the
display and you can now control the Bluetooth device through the unit.
" " will light up when a phone is connected.
" " will light up when an audio device is connected.
Once the connection is established, the device is registered to the unit and there is no need to
perform the pairing again unless you delete the registered device.
Some Bluetooth devices may not be able to connect to the unit after pairing. Connect the device to
the unit manually. Refer to the instruction manual of the Bluetooth device for more information.
Connecting/Disconnecting a registered device manually
To connect
1
(Hold)
2 Select <CONNECT>.
3 Select the desired device.
"CONNECTING" "[Device Name]" scrolls on the
display when the unit is connecting to the device.
"CONNECTED" "[Device Name]" scrolls on the
display when the device is connected.
4 Press MENU to exit.
<BLUETOOTH>
<PHONE>/<AUDIO>
<CONNECT>
Bluetooth connection
(B) If "[Device Name]" "VOL – YES"
"BACK – NO" scrolls on the display,
Select "YES" to start the pairing.
(1) If "PAIRING" "PIN 0000" scrolls on the
display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before
pairing. (
page 25)
(2) If only "PAIRING" appears, operate the
Bluetooth device to confirm pairing.
To disconnect
1
(Hold)
2 Select <DISCONNECT>.
3 Select the desired device.
"DISCONNECT" "[Device Name]" scrolls on the
display when the device is disconnected.
4 Press MENU to exit.
<BLUETOOTH>
<PHONE>/<AUDIO>
<DISCONNECT>
ENGLISH |
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kd-r730bt

Table des Matières