EIBENSTOCK END 1550 P Notice Originale page 21

Voltage differences of + 6 % to – 10 % are allowed.
Use only extension cable with sufficient cross-section (see chart). A cross-
section which is too small could cause a failure of the machine.
Recommended minimum cross-sections and maximum cable lenghts
Mains Voltage
110 V
230 V
The machine is equipped with a soft start which prevents that swift
automatic circuit breakers are unintentionally triggered.
Additional Handle
For manual operation of the END 1550 P always use the additional handle.
This one has to be attached from ahead on the gearbox neck and tightened
by turning the handle. At the same time the water supply has to be mounted
at the handle (see Fig. 1 A).
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and let it go off again
Attention!
Only press the lock-on button when using a stand. In case of
!
every stop of the machine, the lock-on button has to be
released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the
machine (physical hazard).
The END 1550 P is equipped with an adjusting wheel in order to allow a
stepless variable control of speed from 1800 to 4400 rpm. The adjusting
wheel is on the switch grip (see fig. 1 B).
Cross-Section mm²
1.5
20 m
50 m
Rated speed
1 = 1800 rpm
2 = 2000 rpm
3 = 2500 rpm
4 = 3100 rpm
5 = 4400 rpm
21
2.5
40 m
80 m
Drilling diameter
40 – 50(68) mm
30 – 40 mm
20 – 30 mm
15 – 20 mm
6 – 15 mm