EIBENSTOCK END 1550 P Notice Originale page 20

Don't use the machine if a part of the housing is damaged or in case
of damages on the switch, the connecting cable or plug.
When using the drill, always lead the line cord, extension cable and
suction tube backwards away from the machine.
Electrical tools have to be inspected visually by a specialist in regular
intervals.
When using the drill, cooling water is not allowed to get into the
motor and all electrical parts.
Overhead-drilling only with suitable safety measures (water
collection).
If water comes out of the drainage hole at the gear neck, stop your
work and have the tool repaired by an authorised service centre.
After an interruption of work the machine should only be switched on
again if the drill bit can be turned.
Do not touch rotating parts.
Keep the handles dry, clean and free of oil and grease.
Persons under 16 years of age are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable goggles, helmets, ear protectors, protective cloves and
boots.
Always work with concentration. Always work in a carefully
considered way and do not use the tool when you are not
concentrated.
During manual operation, always hold the machine with both
hands and maintain a safe standing position. Always consider
the reaction moment of the machine in case of blockage.
For further safety instructions please refer to the enclosure!
The END 1550 P is made in protection class II. For protection purposes the
machine can only be run with a GFCI. The machine is standard equipped
with a PRCD protective switch integrated in the cord .
Attention!
The PRCD protective switch must not lay in water.
!
PRCD protective switches must not be used to switch
the tool on and off.
Before starting your work, check the proper function
by pressing the TEST button.
First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate.
Electrical Connection
20