Thermador PCG304G Guide D'utilisation Et D'entretien page 15

Checking Burner Cap Placement
• Check each burner to make sure there is no gap
between the burner cap and burner base. See Figure 6
and Figure 7 for examples of correct and incorrect
placements of the burner cap.
• You may gently try to move the burner caps from side
to side to check if the caps are properly placed on the
burner bases. When properly placed, each burner cap
will rest flat on top of its burner base, and completely
cover the star-shape of the burner base when viewed
from the top as shown in Figure 6.
Figure 6: Correct Burner Cap Placement
Figure 7: Incorrect Burner Cap Placement
English 10
Burner Cap Placement
The burner caps must be properly placed on the burner
bases for the rangetop to function properly. If the burner
cap is not properly placed, one or more of the following
problems may occur:
• Burner flames are too high.
• Flames shoot out of burners.
• Burners do not ignite.
• Burner flames light unevenly.
• Burner emits gas odor.
WARNING!
To prevent burns, do not touch burner caps or grates
while hot. Turn the rangetop off and allow the burners to
cool.
WARNING!
To prevent flare-ups and avoid the creation of harmful
by-products, do not use the rangetop without all burner
caps and all burner grates properly positioned.
Electronic Single Point Ignition
Burner Base Burner Base Burner Base
Figure 8: STAR Burner Components
®
Each STAR burner has its own electronic igniter that
sparks when the burner is turned on. Each burner should
light in 4 seconds or less. If a burner does not light, check
to see that the burner cap is positioned correctly on the
base (see Figure 6 and Figure 7).
Burner Cap Burner Cap Burner Cap
Igniter Igniter Igniter