Publicité
Les langues disponibles
Les langues disponibles
•
After impacting preset numbers, the indicating
lamp lights in green color.
•
The red color light will light on if the trigger is released
before the presetting number of impacts is achieved. It
indicates that the operation is incomplete.
•
When auto-stop mechanism is working, the indicating
lamp lights red while the switch trigger is being pulled.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing driver bit or
socket bit
12 mm
(15/32")
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
2
► 1. Sleeve 2. Bit
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
•
If the bit is not inserted deep enough into the sleeve,
the sleeve will not return to its original position and
the bit will not be secured. In this case, try re-insert-
ing the bit according to the instructions above.
9 mm
(3/8")
1
OPERATION
[*1] Presetting number of impacts is impossible for more
than 200 impacts (4 seconds).
[*2] Fastening time includes when you pull the trigger
completely.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque, fastening time and number of impacts
(presetting number) is shown in the figures.
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
.
N m
Standard bolt DTD044
.
(ft lbs)
25
(19)
20
(15)
15
(11)
10
(7)
5
(4)
0
0
0.5
Fastening time
29
(13)
Number of impacts
(Presetting number)
High tensile bolt DTD044
.
N m
.
(ft lbs)
20(14)
18(13)
16(12)
14(11)
12(9)
10(7)
8(6)
6(4)
4(3)
2(1)
0
0
Fastening time
7 ENGLISH
M10(3/8")
M8(5/16")
M6(1/4")
1
1.5
2
Seconds
*1
58
*2
(25)
M6(1/4")
1
Seconds
58
(25)
Number of impacts
(Presetting number)
(M10)
(3/8")
(M8)
(5/16")
(M6)
(1/4")
M6
(1/4")
2
*1
116
*2
(50)
Publicité
