Hitachi UC 18YGL Instructions De Sécurité Et Mode D'emploi page 6

English
SPECIFICATIONS
Model UC18YGL
Input power Single phase: AC 120 V, 60 Hz
source
Charging Approx. 30 minutes ... BCL1415, BCL1815
time Approx. 65 minutes ... BCL1430, EBM1830
Charger Charging voltage ........ DC 7.2–18 V
Charging current ........ DC 2.6 A
Weight 1.3 lbs (0.6 kg)
APPLICATIONS
For charging the HITACHI batteries types BCL14, BCL18
series and EBM1830.
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
BCL1415
3. Charging
When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light in red. (See Table 2)
6
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, pilot lamp will blink in red. (At
1-second intervals)
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 2. Make sure it contacts the bottom of the
battery charger.
BCL1430
BCL1815
Fig. 2
NOTE:
If the pilot lamp flickers in red, pull out the plug
from the receptacle and check if the battery is
properly mounted.
When the battery is fully charged, the pilot lamp
will bilink in red slowly. (At 1-second intervals) (See
Table 2)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
EBM1830