Unpacking And Check Contents; Assembly - LEMAN PON250 Manuel D'utilisation

UNPACKING AND CHECK CONTENTS

Tools need:
This machine is shipped complete in one carton.
Separate all parts from packing materials and check each
item with illustration and "bag of loosen parts".
Note:
Make certain all items are accounted for, before discarding
any packing material.
Warning!
To avoid injury, if any parts are missing, do not attempt to
assemble the Belt and Disc sander, unplug in the power
cord, or turn the switch on until the missing parts are
obtained and installed correctly.
Warning!
For your own safety, never connect plug to power source
outlet, or switch on until all assembly steps are complete
and until you have read and understood the entire Owner's
Manual.

ASSEMBLY

Mounting Belt and Disc Sander to Workbench
If belt and disc sander is to be used in a permanent location,
it should be fastened securely to a firm supporting surface
such as workbench.
If mounting to a workbench, holes should be drilled through
supporting surface of the workbench using dimensions
illustrated.
1.The unit should be bolted securely using M8 screws and
hex nuts (not included). Screw length should be 50mm
plus the thickness of bench top.
ITEM
A Belt & Disc Sander Assembly
B Owner's Manual
C Table
D Sanding Disc
E Mount, Support Table
F Table Support W/Scale
G Work Table for Belt
H Bag of Loosen Parts
Contain:
Hex "L" Wrench 3mm
Hex "L" Wrench 6mm
Sunk head screw M6x16
Pan head screw M6x16
Hex nut M6
External lock washer 6mm
Wing nut 6 mm
Flat washer 6 mm
5
EN
DESCRIPTION QTY
1
1
1
1
2
2
1
1
1
1
2
4
4
8
2
2