Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALL
THE
SANDING
TRACKING
WARNING:
To avoid injury from accidental start, make sure tool is
unpluged before aligning.
On the smooth side of the sanding belt, you will find a
"direction arrow". The sanding belt must run in the direction
of this arrow so that the splice does not come apart.
1.
Removing two lock knob of sander belt work support.
2.
Removing the work support lock pin.
3.
Removing the work support.
4.
Slide tension lever to the left to release the belt tension.
5.
Place the sanding belt over the drums with the direction
arrow pointing as shown. Make sure the belt is centered
on both drums.
6.
Slide tension lever to the right to apply belt tension.
7.
Tighten hex socket screw when bed is in desired
position.
8.
Reinstalling the work support.
9.
Plug in the power cord. Turn the switch "ON" and
immediately "OFF", noting if the belt tends to slide off
the idler drum or drive drum. If it did not tend to slide off,
it is tracking properly.
10. If the sanding belt moves toward the disc, turn the
tracking knob clockwise 1/4 turn.
11. If the sanding belt moves away from the disc, turn the
tracking knob counterclockwise 1/4 turn.
12. Turn switch "ON" and immediately "OFF" again, noting
belt movement. Readjust tracking knob if necessary.
BELT-TENSIONING
AND
8
EN
Publicité
Table des Matières
