Getting To Know Your Belt And Disc Sander - LEMAN PON250 Manuel D'utilisation

GETTING TO KNOW YOUR BELT & DISC SANDER
Warning:
To avoid injury from accidental start, remove the plug from
power source outlet before making any adjustments.
1. Hex socket head screw. Loosening screw allows belt bed
to raise to the vertical position.
2. Tracking knob. Turning knob counterclockwise causes
sanding belt to move towards the disc; otherwise to move
away from the disc
3. Sanding belt.
4. Tension lever. Sliding lever to the right releases the
sanding belt tension; sliding lever to the left applies belt
tension.
5. Work support hex screw.
6. Work support. Supports the workpiece on the sanding
belt.
7. Base
8. Belt bed.
9. Mounting holes.
10. No-volt switch
11. Sanding Disc.
12. Sanding paper.
13. Work table assembly.
9
EN