Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Always sand outside curves on the left side of center on the
sanding disc as shown.
Warning:
Applying the workpiece to the right side of the disc could
cause workpiece to fly up( kickback) and result in an
injury.
SANDING SMALL END SURFACES ON THE SANDING
DISC
Note:
Use
of
a
mitre
gauge
recommended of this operation.
Always move the work across left side of center on the
sanding disc face as shown.
Warning:
Applying the workpiece to the right side of the disc could
cause workpiece to fly up( kickback) and result in an
injury.
Warning:
For your own safety, remove the plug from power source
outlet before adjusting your sander.
Note:
Use a combination square to square the mitre gauge to
the face of the disc( combination square must be "true".
If it is not square, loosen the mitre gauge knob and move
the mitre gauge, tighten the knob securely.
Always position the workpiece to the left of center on the
sanding disc with disc rotating counterclockwise as shown .
The table may be tilted for beveled work.
(optional
accessory)
is
EN
16
Publicité
Table des Matières
