Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Loosen 4-M8 hex head screw with wrench to allow pulley
to shift enough to place belt around them.
around motor pulley and drive pulley as shown if belt is
ever broken.
4. Adjust tension of the belt by putting a wrench in adjusting
gap.
Push up on wrench to tighten tension between
pulleys.
5. Tighten 4-M8 hex head screws careful.
6. Test belt tension by placing fingers on either side of the
belt and squeeze. There should be about a 6mm give to
the belt.
Note:
Excessive tightness on pulley belt may cause increased
noise and over load motor. Excessive looseness on
pulley belt may cause belt to fail prematurely.
7. Locate the pulley cover and position inside the relied
edges of pulley housing.
8.Using a Phillips screwdriver, reinstall and tighten 3-pan
head screws.
Place belt
18
EN
Publicité
Table des Matières
