LEMAN PON250 Manuel D'utilisation page 53

3.Put a 6mm washer and a wing nut on the screw and
tighten.
Install Table
1. Use 2-M6x16 pan head screw fastening a table support
mount on the front of sander.
2. Place the support table w/scale onto the table support
mount.
3. Put a 6mm flat washer on the table lock knob, and place
the knob into the tilt scale plate and mount. Hand tight it.
4. place the table onto support table, align the 4-screw which
preassembled under the table with the holes of table
support.
5. Put the external lock washer and hex nut onto the screws,
and tighten them.
6. Adjust the table and retighten the table lock knobs.
Warning:
To avoid trapping the work or fingers between the table and
sanding surface, the table edge should be a maximum of 2
mm from sanding surface.
7. Loosen 4-M6 hex nuts under the table.
8. Use your owner's manual as a spacer. Place ten pages of
owner's manual between the disc and the front edge of
the table. Hold the table against the manual and tighten
the 4-M6 hex nuts.
Squaring Table assembly
WARNING:
To avoid injury from accidental start, make sure tool is
unpluged before aligning.
1. Use a combination square, check the angle of work table
with the disc.
NOTE: The combination square must be " true".
2. If the table is not 90 degree with the disc, loosen table lock
knob screw and tilt table.
3. Adjust worktable square to the disc and retighten table
lock knob.
4. Adjust the pointer to zero mark on the scale plate.
7
EN