Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WHEN SANDER IS RUNNING
WARNING:
Don't let familiarity (gained from frequent use of your belt
and disc sander) cause a careless mistake. A careless
fraction of a second is enough to cause a severe injury.
Before starting your work, watch the sander while it runs. If it
makes an unfamiliar noise or vibrates a lot, stop immediately.
Turn the sander off. Unplug the sander. Do not restart until
finding and correcting the problem.
Make sure the sanding disc turn counterclockwise before
using the sander.
KEEP CHILDREN AWAY. Keep all visitors a safe distance
from the sander. Make sure bystanders are clear of the
sander and workpiece.
DON'T FORCE TOOL. It will do the job better and safer at its
designed rate. Press the workpiece against the sanding
material only hard enough to let it sand without bogging down
or binding.
Before freeing any jammed material:
Turn the switch "OFF".
Unplug the sander
Wait for all moving parts to stop.
BEFORE LEAVING THE SANDER:
NEVER LEAVE TOOL RUNNING UNATTENDED. TURN
POWER OFF. Don't leave tool until it comes to a completed
stop.
MAKE WORKSHOP CHILDREN_PROOF. Lock the shop.
Disconnect master switches.
13
EN
Publicité
Table des Matières
