Elem Garden Technic WTTAC41T-CC99 Traduction Des Instructions D'origine page 89

Change Engine Oil
Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
Wipe the oil filler area clean, then remove the oil filler cap/dipstick.
Place a suitable container next to the mower to catch the used oil, then tilt the mower
on its right side. The used oil will drain through the filler neck. Allow the oil to drain
completely.
Please dispose of used motor oil and the containers in a manner that is compatible
with the environment. We suggest you take it in a sealed container to your local
recycling center or service station for reclamation. Do not throw it in the trash, pour it
on the ground, or pour it down a drain.
Fill with the recommended oil. Do not overfill. Allow a couple of minutes for the oil to
settle in the engine, then measure the oil level.
Air Cleaner Service
NOTICE: Operating the engine
without an air cleaner, or with a
damaged air cleaner, will allow dirt
to enter the engine, causing rapid
engine wear.
Press down on the cover tabs and
remove the cover.
Remove the filter from the air
cleaner base..
Inspect the filter and foam
element, and replace it if
damaged.
Clean the filter by tapping it several times on a hard surface to remove dirt, or blow
compressed air through the air filter from the inside. Never try to brush off dirt;
brushing will force dirt into the fibers.
Wipe dirt from the inside of the air cleaner base and cover, using a moist rag. Be
careful to prevent dirt from entering the air duct that leads to the carburetor.
Reinstall the filter and cover.
89