Incompatible Vehicle Seat Belts; Maintenance; Seat Cover - Britax MARATHON Guide D'utilisation

BRITAX Child Safety, Inc.
c. Tightens by feeding
the belt webbing
back into the
retractor.
2. Locking Latch Plate
a. Has a latch plate
that prevents the
webbing from
becoming loose.
NOTE: Ensure the latch
plate and vehicle belt
lie flat against the child
seat or the vehicle belt
may remain unlocked.
b. Tightens by pulling
on the belt webbing.

Incompatible Vehicle Seat Belts

The following types of vehicle seat belts are NOT
compatible with this child seat. If any of the belt types
listed below are in the chosen seating position, choose
another vehicle seating position or check your vehicle
owner's manual for information on installing a car seat in
your vehicle.
Lap belts with a sewn-in
latch plate that have a
retractor that locks only in
case of a sudden stop.
Lap-shoulder belts with top
or bottom anchor points on
the vehicle door.
34
Latch plate
Adjuster
Lap belts forward of
the vehicle seat bight.
Motorized, automatic
vehicle seat belts.

Maintenance

Seat Cover

Removing the Cover
Never remove the buckle tongues from the harness.
They cannot be reattached after removal. If reassembled
incorrectly, the child seat may not perform as intended.
1. Loosen and unbuckle the
harness.
a. Lift harness adjuster
lever.
b. Pull both harness
straps forward.
c. Unbuckle the
harness.
2. Open the chest clip.
a. Press tabs
b. Pull apart
3. Remove the infant
positioning pillow if
necessary.
4. Remove the belly pad and
buckle.
a. Lift the cover from
the seat to find
the buckle strap
connection.
b. Remove the buckle
strap by turning
the buckle retainer
sideways and routing
it out of the front
buckle slot in the child
seat (see page 38).
c. Slide the end of the
belly pad over the
comfort foam on the
seat.
MARATHON Canadian User Guide
1b
1a
a
2a
4a
4b
4c
b
2b
35