Hoover VELOCITY EVO Manuel D'utilisation page 8

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

User checklist
If your cleaner is not working properly run through the
following checklist.
1.
Is there a working electricity supply to the cleaner?
Check with another electrical product.
2.
Is the bin full or choked with fine dust?
To empty the bin, see the User Manual on P5.
3.
Is the hose blocked?
To clear a blockage, see the User Manual on P6.
4.
Is there a blockage in the cleaner base?
To clear a blockage, see the User Manual on P6.
5.
Are the filters blocked?
To clean filters, see the the Manual on P5.
6.
Are the brushes rotating correctly?
To check the brushes, see the User Manual on p6.
7.
Has the cleaner overheated?
If so, it will take about 45 minutes to reset.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in working order, has not been assembled in accordance
with these instructions or has been used incorrectly.
WARNING! A thermal cut out switches off the cleaner to prevent overheating if it is
used when full or there is a blockage or dirty filters. If this should happen switch off,
unplug and correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
IMPORTANT: Do not run cleaner over the power cord as this could damage the
power cord insulation.
IMPORTANT INFORMATION
Hoover Service
Should you require service at any time, please contact your local Hoover Service
Office.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your
local Hoover dealer or direct from Hoover. When ordering parts always quote
your model number.
Hoover's factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of ISO 9001
GUARANTEE STATEMENT
The guarantee conditions for this appliance are as defined by our representative in
the country in which it is sold. Details regarding these conditions can be obtained
from the dealer from whom the appliance was purchased. The bill of sale or receipt
must be produced when making any claim under the terms of this guarantee.
Subject to change without notice.
- 7 -
Quality
GB

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ve01

Table des Matières