Selecting The Incoming Call Screen; Audio Adjustments; Introduction Of Audio Adjustments - Pioneer DEH-P7900BT Mode D'emploi

Section
02 Operating this unit
Displaying BD address of this unit
1 Use MULTI-CONTROL to select
Device info. in the function menu.
The device name (e.g., Pioneer BT unit) of this
unit appears in the display.
2 Push MULTI-CONTROL left to switch to
the BD address.
12-digit hexadecimal string is displayed.
# Pushing MULTI-CONTROL right returns to the
device name.

Selecting the incoming call screen

It is possible to select an incoming call screen.
Since the screen selection is available for
each user, it is possible to select different
screens between the users.
1 Press MULTI-CONTROL to display the
main menu.
FUNCTION, AUDIO, ENTERTAINMENT and
RECEIVING MOVIE appear on the display.
2 Use MULTI-CONTROL to select
RECEIVING MOVIE.
Turn to change the menu option; press to se-
lect.
3 Use MULTI-CONTROL to select the
screen.
Turn to change the menu option; press to se-
lect.
Screen 1—Sceen 2—Screen 3—Screen 4
40
En

Audio Adjustments

Introduction of audio adjustments

1 1 1
1 Audio display
Shows the audio adjustment status.
1 Press MULTI-CONTROL to display the
main menu.
FUNCTION, AUDIO and ENTERTAINMENT
appear on the display.
2 Use MULTI-CONTROL to select AUDIO.
Turn to change the menu option; press to se-
lect.
The audio function name appears on the dis-
play.
3 Turn MULTI-CONTROL to select the
audio function.
Turn MULTI-CONTROL to switch between the
audio functions in the following order:
Fader (balance adjustment)—Powerful (gra-
phic equalizer adjustment)—50Hz (7-band
graphic equalizer adjustment)—LOUD (loud-
ness)—Sub W.1 (subwoofer on/off setting)—
Sub W.2 (subwoofer setting)—Bass (bass
boost)—HPF (high pass filter)—SLA (source
level adjustment)
# You can also select the audio function by
pressing AUDIO on the remote control.
# You can select the Sub W.2 only when sub-
woofer output is turned on in Sub W.1.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# To return to the display of each source, press
BAND.
# If you do not operate functions except for
50Hz within about 30 seconds, the display is
automatically returned to the ordinary display.