Makita BO5040 Manuel D'instruction page 5

Refer to the figure for the relationship between the
number settings on the adjusting dial and the kind of
work.
A range: For polishing
B range: For finish sanding
C range: For regular sanding
12000
4000
B
A
1
2 3
Dial setting
003291
NOTE:
The figure shows standard applications. They may
•
differ under certain conditions.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
How to use the front grip
011029
The front grip can be loosened and moved horizontally to
a desired working position. Once the front grip is in the
desired position, retighten before using.
Installing or removing the front grip
1
2
011027
Open the grip base, and attach it to the sander in the
area of the Makita logo.
C
4 5
011028
After closing the grip base, firmly tighten on the front grip
to the screw section of the grip base.
011030
To remove, loosen and remove front grip, and then
remove grip base.
Installing or removing abrasive disc
010745
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then peel off the backing paper
from the abrasive disc and attach the abrasive disc to the
pad. Be careful to align the holes in the abrasive disc with
those in the pad.
CAUTION:
If you peel off the abrasive disc from the pad, its
•
adhesion will become poor. Never attempt to stick it
onto the pad for further use.
5
1. Grip base
1