Location Requirements; Electrical Requirements - Haier QPCD10AXLW Guide De L'utilisateur

• •
Exhaust Exhaust
Nozzle (1 or Hose (1 or 2
depending on
2 depending
model)
on model)
• •
Flat Screws (6) Pointed
Screws (7)
4 for
2 for top
extension
window
panels
brackets
2 for nozzles
1 for security
bracket
4 for main
window panel
• •
Bottom Security
Window Bracket
Bracket (2)
• •
Top Foam Strip Bottom Foam
(10 mm x 10 Strip
mm x 102 cm) (3 mm x 10 mm
x 102 cm)

LOCATION REQUIREMENTS

•
location that is at least 20" (51 cm) from any wall.
NOTE: The recommended distance from the window for
optimal performance is 30" (76 cm).
•
Maintain a minimum 20" (51 cm) clearance around the air
•
Keep the air conditioner free of any obstructions such as
drapes, curtains, blinds, etc.
•
The exhaust hose should be free of any obstructions.
•
Do not place the air conditioner on an unstable or raised
•
Do not place the air conditioner in direct sunlight or near
a heat source such as baseboard heaters, stoves, etc.
•
The window panel can be installed in a window with a
minimum 20" (51 cm) to a maximum 40" (101.6 cm)
opening.
•
Hose Connector
(1 or 2 depending
on model)

ELECTRICAL REQUIREMENTS

•
Top Window
Bracket (2)
•
Remote Control
•
Batteries (2)
POWER SUPPLY CORD
Wiring Requirements
•
•
•
If this power supply cord is damaged, it cannot be repaired. It
must be replaced with a cord from the product manufactur-
er. If the power supply cord is damaged call Haier Customer
Service: 1-877-337-3639.
To test the power supply cord before operation:
1. Plug the power cord into a grounded 3 prong outlet.
2. Press the Test button, and then press and release the
4
20"
(51 cm)
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power cord
plug.
Do not use an adapter.
Do not use an extension cord.
shock.
115 Volt, 60Hz, 15-amp fused grounded 3 prong outlet
The use of a time-delay fuse or time-delay circuit breaker
is recommended.
Use a dedicated circuit only.
NOTE: Do not operate any other electrical appliances on
this circuit or you may trip the circuit breaker/fuse.
Reset button to restore power.
20"
(51 cm)
RESET
TEST