GE VAT300 Guide Rapide page 28

Chapter 5 Parameter Settings
5-1 Monitor parameters
No. Parameter
D00 – Output frequency monitor
0 Output frequency in Hz
1 Output frequency in %
D01 – Frequency setting monitor
0 Set frequency in Hz
1 Set frequency in %
D02 – Current monitor
0 Output current (Amps)
1 Output current (%)
2 Overload (OL-1) monitor
Motor overload (OL-3)
3
monitor
4 Heatsink temperature
U phase output current
7
amps
V phase output current
8
amps
W phase output current
9
amps
D03 – Voltage monitor
0 DC voltage
1 Output voltage (command)
2 Output power
3 Carrier frequency
D04 – Sequence status
Sequence status-Input 1
0-3
to 4
Sequence status-Output 1
4-7
to 4
D05 – Minor fault monitor
0 Minor fault failure monitor
Hardware detection fault
1
status
A state of ON/ off of the internal sequence data is indicated as follows.
(For V24-O P 1)
AFS3
PROG
CFS
COP
BRAKE
EXC
Sequence Input(D04-0)
Unit
will display when the drive is in standby.
Hz
displays while the DC brake is in action.
%
Hz The currently selected frequency setting value is displayed.
% The max. frequency is displayed as 100%.
A will display when the drive is in standby.
% The motor rated current is displayed as 100%.
% OL-1 functions when this value reaches 100%.
% The OL-3 operates when at 100%.
°C Depending on the capacity, OHT.1 functions at 95°C or 120°C or more.
A
will display when the gate is closed.
A
The correct value is not displayed during pick-up or during automatic tuning.
A
V Displays the voltage of the DC link circuit in the main circuit.
Displays output voltage command. The display may differ from the actual output
V voltage. It depends on the power supply voltage.
closed.
kW Displays the inverter's output power.
The current carrier frequency is displayed.
The ON/OFF state of the internal sequence data will display.
The correspondence of each LED/LCD segment and signal is shown in the next
page.
The internal minor fault status will display.
The status of the fault signal detected by the hardware is displayed.
AFS1
AFS2
CPASS
IPASS
CSEL
EMS
RESET
RUN
JOG
REV
Remarks
is displayed during pick up.
(For V24-O P2)
S5
S6
S7
MBRK_ans
BUP
FDW
FUP
SE
Sequence Input(D04-1)
EN-26
will display when the gate is
will display when the gate is closed.
PICK
AUXDV
IVLM
BDW
S0
S1
S2
S3