Reliable Enviromate E3 Guide D'utilisation page 10

The nylon brush, because of its softness, is ideal for removing the dirt in grout,
sinks and other surfaces where you need some light scrubbing action, but need
to be careful not to scratch the surface.
Tougher cleaning jobs may require the use of the brass brush that is supplied.
Please make sure you are careful that it does not scratch the surface with this
tool. Brass is tougher than nylon, but softer than stainless steel. For surfaces
(grout for example) where the dirt is not being properly lifted with the nylon brush,
carefully using the brass brush may give the best results.
For the toughest cleaning assignments (very caked on grease, rust, barbeque
grills, very dirty grout), we recommend that you purchase the optional stainless
steel brush that is available through your dealer.
When using the steam nozzle with or without the brushes, you will need a cloth to
wipe up the moisture and dirt that has been lifted through cleaning.
FILLING THE TANK
If the (low) water level control light (4) comes on during usage, and you would like
to continue using the steam cleaner, you will need to follow the following steps:
1. Turn the main switch (1) to the 1st position (this shuts off the power to the
heating element).
2. Hold the steam control on the handle (11) until all the steam has evacuated
the steam cleaner.
3. When there is no more steam, turn the main switch to the off position.
4. It is now safe to open the water tank cap (6). Refill the steam cleaner with
warm (for faster heat up) water, refasten the water tank cap, turn main switch
(1) to the 2nd position and wait for the steam control light (3) to turn on.
MAINTENANCE OF THE BOILER
To maintain your steam cleaner in good condition and to ensure constant perfor-
mance, we recommend that you periodically clean the boiler once or twice a year
depending on the hardness of the water.
CLEANING INSTRUCTIONS
ATTENTION: Before cleaning the boiler with the supplied de-scaling powder, please
make sure that the boiler is at room temperature, that it has not been used for at
least 8 hours, and that the boiler is disconnected from the power source.
1. Unscrew and remove the filling cap (6), turn the steam cleaner over and elimi-
nate all water remaining in the boiler.
08