Becker Centronic SunWindControl SWC442-II Notice De Montage Et D'utilisation page 20

Assembly and Operating Instructions
2) Learning the master transmitter
a) Put receiver into learn mode
Note
The master transmitter is the very first transmitter programmed on a
receiver. In contrast to subsequently programmed transmitters, the
master transmitter enables, among other things, the setting of limit po-
sitions (for drives with integr. radio receiver) and the programming or
deleting of further transmitters.Any transmitter which has a separate
UP, STOP, DOWN button and a programming button can be a master
transmitter.
Always follow the installation and operating instructions of the receiver.
Use a suitable cylindrical tool (e. g. ball-point pen) to actuate the pro-
gramming button on the transmitter.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Actuate the programming button or the radio-controlled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learn master transmitter
Press the programming button of the master transmitter in programming mode
until the receiver acknowledges successful programming.
The learn process is now complete.
3) Learning additional transmitters
a) Press the learn button of the master transmitter until acknowledgement is
given by the receiver.
b) Now press the learn button of the new transmitter until acknowledgement is
given by the receiver
c) Then press the learn button of the new transmitter to be learnt once again.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 25 m outside and inside the building and up
to 350 m in the open.
20