Makita 9902 Manuel D'instruction page 6

OPERATION
Sanding operation
CAUTION:
The tool should not be in contact with the workpiece
•
surface when you turn the tool on or off. Otherwise
a poor sanding finish or damage of the belt may
result.
003391
Hold the tool firmly with both hands. Turn the tool on and
wait until it attains full speed. Then gently place the tool
on the workpiece surface. Keep the belt flush with the
workpiece at all times and move the tool back and forth.
Never force the tool. The weight of the tool applies
adequate pressure. Excessive pressure may cause
stalling, overheating of the motor, burning of the
workpiece and possible kickback.
Sanding shoe (optional accessory)
003394
The sanding shoe readily allows you to sand workpieces
more evenly.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
1. Sanding shoe
1
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
2
003396
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Abrasive belts
•
Sanding shoe
•
Dust bag
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
6
1. Limit mark
1
1. Brush holder cap
2. Screwdriver
or attachments
Only use accessory or
are