Makita 9902 Manuel D'instruction page 5

CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded,
resulting in tool malfunction.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or the
speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing abrasive belt
003501
Pull the lever all the way out and install the belt over the
rollers, and then return the lever to the original position.
CAUTION:
When installing the belt, make sure that the
•
direction of the arrow on the back of the belt
corresponds to the one on the tool itself.
003376
Adjusting belt tracking
more than 6mm (1/4")
003380
1. Lever
1
1. Steel plate
1
2. Adjusting knob
2
Switch on the tool and make sure that the belt is aligned
properly. If the edge of the belt extends beyond the edge
of the base or the edge of the belt retracts more than 6
mm (1/4") away from the edge of the base, use the
adjusting knob to adjust the belt tracking.
Dust bag
2
003385
Attach the dust bag onto the dust spout. The dust spout
is tapered. When attaching the dust bag, push it onto the
dust spout firmly as far as it will go to prevent it from
coming off during operation.
When the dust bag is about half full, remove the dust bag
from the tool and pull the fastener out. Empty the dust
bag of its contents, tapping it lightly so as to remove
particles adhering to the insides which might hamper
further collection.
1
2
003389
NOTE:
If you connect a Makita vacuum cleaner to this tool,
•
more efficient and cleaner operations can be
performed.
5
1. Dust bag
2. Dust spout
1
1. Dust bag
2. Fastener