Milwaukee 2630-20 Manuel De L'utilisateur page 5

Installing and Removing Blades
1. Remove battery pack before installing or re-
moving blades.
2. Place the saw on a flat surface with the blade fac-
ing upwards. To remove the bolt from the spindle,
push in the spindle lock button. While holding in
the spindle lock button, use the wrench provided
with the tool to turn the bolt clockwise. Remove
the bolt and blade flange.
3. Slide the lower guard lever up to raise the lower
guard. Remove the blade from the spindle. Always
clean the spindle, upper guard and lower guard to
remove any dirt and sawdust.
NOTE: Do not remove inner blade flange. Larger
diameter of inner flange should face the blade.
Spindle
Inner flange
4. To install a blade, place the blade on the spindle
with the teeth pointing in the same direction as
the arrow on the lower guard. Release the lower
guard lever.
5. Place the blade flange on the spindle and hand
tighten the bolt.
6. While holding in the spindle lock button, use the
wrench to turn the bolt counterclockwise and
tighten.
Adjusting Depth
1. Remove battery pack.
2. To adjust the depth of the cut, hold the saw by the
handle and loosen the depth adjusting lever by
pushing it down toward the shoe.
3. Raise or lower the shoe to the desired position.
Markings in 1/4" increments are located on the in-
ner side of the upper guard for depth setting. For the
proper depth setting, the blade should extend no
more than 1/8" to 1/4" below the material being cut.
1/4" 6 mm
( )
4. Lift the depth adjusting lever up towards the motor
housing to secure the shoe position.
1. Remove battery pack.
2. To adjust the angle of the cut, hold the saw by the
handle and loosen the bevel adjusting knob.
Bolt
3. Hold the front of the shoe and rotate the saw by
the handle to the desired angle as indicated by
the markings on the bevel scale.
4. Tighten the bevel adjusting knob securely.
Outer flange
The shoe has been adjusted at the factory to a 90
degree setting. Inspect the saw regularly to make
sure the blade is 90 degrees to the shoe.
1. Remove battery pack.
2. Set the bevel pointer to zero.
3. To make sure the blade is 90 degrees to the shoe,
place saw on the blade side and retract lower
guard. Place a square against the blade and shoe
to inspect the degree setting.
4. To adjust the degree setting, loosen the bevel adjust-
ing knob. Turn the bevel adjustment screw in or out
until the blade is at a 90 degree angle with the shoe.
5. Tighten the bevel adjusting knob securely.
5
Adjusting Bevel Angle
Adjusting the Blade to Shoe
Bevel
adjustment
screw