Angelo Po 0G0FT1E Manuel D'utilisation Et D'installation page 26

To carry out this operation,
proceed as follows.
1 - Fit the rear frame (A)
into the groove provid-
ed.
2 - Fit the side frames (B)
by inserting the pins into
the slots in the rear
frame.
To clean, remove the splash
guard frame and put it in a
dishwasher.
If the appliance is to be out of use for a lengthy
period, proceed as follows:
1 - cut off the mains electricity supply using
the appliance's master switch;
2 - clean the appliance and the surrounding areas
thoroughly;
IT
GB
DE
FR
To ensure correct use of the appliance, the follow-
ES
ing rules should be adopted.
– Use only the accessories recommended by the
constructor.
– Never use the appliance for frying in large
amounts of oil.
– Never use the appliance to heat pans as this will
damage the surface of the cooking plate.
– Never use the appliance for cooking frozen
foods, since the temperature difference might
damage the surface of the cooking plate (for
English
FITTING THE SPLASH GUARD FRAME
LENGTHY APPLIANCE DOWNTIMES
USEFUL ADVICE FOR USE
B
3 - spread a film of edible oil over the stainless
steel surfaces;
4 - carry out all the servicing procedures;
5 - cover the appliance, leaving a few gaps to allow
air to circulate.
chromium-plated plates and compound only).
– Take care not to scratch or chip the surface of the
plate, to ensure maintenance of its characteris-
tics and hygienic cooking.
– Use only metal tools for moving or removing
foods on the cooking plate (for chromium-plated
plates only).
– Always keep the appliance and the surrounding
areas clean.
– When cleaning, use only food-approved deter-
gents.
- 8 -
A
IDM-39603604100.tif