Sony VPH-D50Q Mode D'emploi page 9

Control Panel
1
INPUT SELECT
LIGHT VIDEO
NORMAL SELECT
VIDEO/S VIDEO
!£
1 LIGHT key
Illuminates the key indicators on the control panel. The
key indicators turn off if you press the LIGHT key
again.
If you do not press any key for more than 30 seconds,
the indicators also turn off automatically.
2 INPUT SELECT keys
Select the input signal.
VIDEO: The video or S video signal input from the
VIDEO IN or S VIDEO IN (or Y/C IN) connectors
SELECT VIDEO/S VIDEO: Selects the signal input
from the VIDEO IN or S VIDEO IN (or Y/C IN)
connectors by pressing this key after pressing the
VIDEO key.
A: The RGB, component or HDTV signal input from
the INPUT A connectors
B: The signal input from the INPUT B section when
the optional interface board other than the IFB-40 is
installed
Note
To switch the input signal from the INPUT A or INPUT B
to the S VIDEO IN (or Y/C IN) connectors, first press the
VIDEO key, then press the SELECT VIDEO/S VIDEO key.
The keys with the same names as those on the remote control have the
same functions. The functions of the keys and switches that are not on the
control panel can be selected with the menu operation.
2 3 4 5 6 7 8
PICTURE CONTROL STATUS MUTING RGB
A B BRIGHT CONTR ON PIO SIZE
+ +
- - --
OFF BLKG SHIFT
!¢ !∞
9 !º
POWER
CENT
R MEMORY MENU
B RESET ENTER OFF
!§
3 PICTURE CONTROL keys
Adjust the picture conditions: CONTR (contrast) and
BRIGHT (brightness).
4 STATUS ON/OFF key
Press OFF to eliminate the on-screen display.
Press ON to restore the on-screen display.
Note
The menus and warning messages appear even if the OFF
key is pressed.
5 MUTING PIC key
Cuts off the picture. To restore the picture, press the
key again.
!¡ !™
ON
STANDBY
IR
!¶
9
(EN)