Sony VPH-D50Q Mode D'emploi page 15

!¶ SWITCHER/VIDEO MEMORY/INDEX select
switch
Selects the function of the SWITCHER/VIDEO
MEMORY/INDEX keys.
Set to SWITCHER to select the input from the PC-
1271/1271M Signal Interface Switcher.
Set to VIDEO MEMORY to select the set and adjusted
video memory data.
Set to INDEX to assign the index number of each
projector when multiple projectors are used.
!• INPUT SELECT keys
Select the input signal.
VIDEO: The video or S video signal input from the
VIDEO IN or S VIDEO IN (or Y/C IN) connectors
SELECT VIDEO/S VIDEO: Selects the signal input
from the VIDEO IN or S VIDEO IN (or Y/C IN)
connectors by pressing this key after pressing the
VIDEO key.
A: The RGB, component or HDTV signal input from
the INPUT A connectors
B: The signal input from the INPUT B section when
the optional interface board other than the IFB-40 is
installed
C, D: These keys do not function with this projector.
Note
To switch the input signal from the INPUT A or INPUT B
to the S VIDEO IN (or Y/C IN) connectors, first press the
VIDEO key, then press the SELECT VIDEO/S VIDEO key.
!ª SYS SET key
This key does not function with this projector.
@º PATTERN key
Displays the internal test patterns of the projector.
Each press of the key displays CROSS HAIR, HATCH
(9 × 9), ME and COLOR BAR patterns, sequentially.
@¡ LCD LENS CONTROL keys
These keys do not function with this projector.
@™ NORMAL key
Erases the test pattern or cancels the various
adjustment modes.
@£ MUTING keys
PIC (picture): Cuts off the picture. To restore the
picture, press the key again.
AUDIO: This key does not funcion with this projector.
@¢ CONTROL S OUT jack
Connects to the CONTROL S IN/PLUG IN POWER
jack on the projector for wired remote control
application.
15
(EN)