Bosch GHP 8-15 XD Notice Originale page 15

OBJ_BUCH-1763-003.book Page 15 Monday, July 17, 2017 3:36 PM
Pressure washer
Weight according to EPTA-
Procedure 01:2014
Protection class
Serial number
The values given are valid for a nominal voltage [U] of 230 V. For differ-
ent voltages and models for specific countries, these values can vary.
Starting cycles generate brief voltage drops. Interference with other
equipment/machines may occur in case of unfavourable mains system
conditions. Malfunctions are not to be expected for system impedances
below 0.153 ohm.
Noise/Vibration Information
Sound emission values determined according to
EN 60335-2-79.
Typically the A-weighted noise levels of the product are:
Sound pressure level 85,5 dB(A); sound power level
93 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60335-2-79:
2 2
a =4.91 m/s , K=1.5 m/s .
h
Mounting and Operation
Action
Delivery Scope
Handle Assembly
Mounting the hose
Insert dip stick for ventilation
Filling up detergent tank
Connecting to the water supply
Clean the water filter
Connecting high pressure water supply
hose/nozzle
Adjust water pressure
Adjust water jet
Switching On and Off
Clean nozzle
Starting
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
Your machine is double insulated for safety and requires no
earth connection. The operating voltage is 230 V AC, 50 Hz
(for non-EU countries 220 V, 240 V as applicable).
Bosch Power Tools
For increased electrical safety use a Residual Current Device
GHP 8-15 XD
(RCD) with a tripping current of not more than 30 mA. Always
check your RCD every time you use it.
kg 40.6
The supply cables must be inspected for signs of damage at
/I
regular intervals and may only be used if in perfect condition.
See serial number
If the replacement of the supply cord is necessary, this has to
(rating plate) on pressure
be done by Bosch or an authorized Bosch service agent in or-
washer.
der to avoid a safety hazard.
Only use approved extension cables.
Extension cords, cables, leads, reels should only be used if
they comply with EN 61242/IEC 61242 or
IEC 60884-2-7.
If you want to use an extension cable when operating your
product, only the following cable dimensions should be used:
– Nominal Conductor Area of 1.5mm
of 20m for a Cord Extension Set
The connections (plugs and sockets) should be kept dry and
off the ground.
It is recommended that this is accomplished by means of a
cord reel which keeps the socket at least 60 mm above the
ground.
Note: If an extension cable is used it must be earthed and con-
nected through the plug to the earth cable of your supply net-
work in accordance with prescribed safety regulations.
Figure Page
Refer to the instruction manual of the extension cord, lead,
1 237
reel manufacturer and your local wiring regulations.
2 238
If in doubt contact a qualified electrician or the nearest Bosch
3 239
Service Centre.
4 240
For products not sold in GB:
5 240
WARNING: For your safety, it is required that the plug at-
6 241 tached to the product is connected with the extension cord.
The coupling of the extension cord must be protected against
7 241
splash water, be made of rubber or coated with rubber. The
extension cord must be used with a cable strain relief.
8 242
Products sold in GB only: Your product is fitted with a
9 242
BS 1363/A approved electric plug with internal fuse (ASTA
10 243
approved to BS 1362).
11 243 If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an author-
12 243
ised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Drawing in water from open reservoirs
– Screw the suction hose with filter (special suction kit part
no. F 016 800 335) to the water connection.
– Switch on the appliance in low pressure mode.
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
et must be of watertight construction and in-
tended for outdoor use.
2
to a max. cable length
1 609 92A 3ES | (17.7.17)
English | 15