Procedure For Removing The Trays; Modifying The Tray Number - Saeco MEGACOLD S Notice Originale

40
E
N
G
fig. 4
L
I
S
H
fig. 5
fig. 6
MEGACOLD S/M – Issue 01
10.3 PROCEDURE FOR REMOVING THE
TRAYS
To replace the tray proceed as follows:
•
Switch off the machine by means of the main
switch and pull out the power plug.
•
Open the main door.
•
Remove the cover from the left light source.
•
Remove the electric connector -A- .
•
Press the right drawer lock plate.
•
Pull out the tray by overcoming the resistance
exerted by the positioning spring (pull gently).
•
Pull the tray until it hits the stop, pull it
upwards, rotate it downwards until it is
released from the guide, then finally remove it
from the machine.
To mount a tray proceed as follows:
•
Insert the tray.
•
Push the tray until it engages in the locked
position.
•
Insert the electric connector -A-.
•
Mount the cover of the light source and
fasten with the screws. Mount the cover of
the light source and fasten with the screws.
•
Close the main door.
•
Energise the machine by means of the main
switch.

10.4 MODIFYING THE TRAY NUMBER

Vending machines with
transformed into machines with 7 trays by
proceeding as follows:
•
Switch off the machine by means of the main
switch and pull out the power plug.
•
Open the door and remove the cover from
the light source.
•
Pull out all the trays from the vending
machine.
•
Move the guides det. B (the last one on the
bottom is already in the correct position
consequently it does not need to be moved).
•
Move the connectors, det. A, placed on the
bottom of the cabinet.
•
Add a pair of guides.
•
Mount 7 trays and check that the connectors
are plugged in correctly.
•
Set the new prices.
6 trays can be