Troubleshooting - Scheppach HS250L Traduction Des Instructions D'origine

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.

17. Troubleshooting

Fault Possible cause
1. Blade dissolves To slightly tightened fastening nut
after switching off
the engine
2. Engine will not a) Failure mains fuse
start
b) Defective extension cable
c) Connections on motor or switch not
in order
d) Motor or switch faulty
3. Motor wrong direc- a) Capacitor faulty
tion of rotation
b) Wrong connection
4. Motor will not work, a) Cross section of the extension cable
the fuse is activ does not suficiently
b) Overload by a blunt saw blade
5. Fire marks on the a) blunt saw blade
cutting surface
b) wrong saw blade
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Batteries and rechargeable batteries do not be-
long in the household waste!
As the consumer you are required by law to
bring all batteries and rechargeable batteries,
regardless whether they contain harmful sub-
stances* or not, to a collection point run by the local
authority or to a retailer, so that they can be disposed
of in an environmentally friendly manner.
*labelled with: Cd = cadmium, Hg = mercury, Pb =
lead
• Remove the batteries from the laser before dispos-
ing of the machine and the batteries.
Possible cause
Tighten the right hand thread nut
a) Check mains fuse
b) Replace extension cord
c) Repair by electrical specialist
d) Repair by electrical specialist
a) Repair by electrical specialist
b) Exchange polarity of outlet by an qualiied electrician
a) see „Electrical connection"
b) Change saw blade
a) Sharpen or change saw blade
b) Change saw blade
GB | 37