Charging And Operating The Appliance - SEVERIN 7158 Mode D'emploi

HV7158.book Seite 18 Dienstag, 19. April 2016 10:28 10

Charging and operating the appliance

Assembly of the appliance
3 Charging and operating the appliance
illustrated Quick Start Guide
Installing the wall mount
Charging the rechargeable battery
It is best to charge the rechargeable battery before each use, especially after the appliance has not
been used for a while.
This increases the service life of the rechargeable battery and ensures the longest possible cleaning
cycles.
1. Plug the included mains adapter into the connection socket of the appliance.
2. Connect the included mains adapter to an outlet.
- The LEDs on the handle start to flash. The more the LEDs flash, the more advanced the charg-
ing process is.
- The LEDs go out once the rechargeable battery is fully charged. The charging process takes
around 3 hours when the rechargeable battery is empty.
3. Pull the mains adapter out of the outlet.
4. Pull the mains adapter from the connection socket on the appliance.
TIP: The operation time with a fully charged rechargeable battery is approximately 30 min-
utes (without switching on the brush roller) or 25 minutes (with the brush roller switched on).
For further information, see also illustrated Quick Start Guide.
18
1. Hold the wall mount to the wall, aligned in a vertical po-
sition.
2. Mark the holes with a pencil.
3. Drill the holes (approximately 8 mm Ø).
4. Insert the supplied dowels into the holes.
5. Fasten the wall mount using the screws supplied.