Husqvarna 436 Li Manuel D'utilisation page 25

To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring works
correctly.
2. Press down the power trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
4. Start the product and apply full power.
5. Release the power trigger and make sure that the
saw chain stops and stays stationary. If the saw
chain rotates when the power trigger is in the idle
position, turn to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the keypad
1. Start the product. See
15
2. Press the start/stop button again.
481 - 001 - 22.01.2018
To start the product on page
3. Make sure that the product stops when you press
and hold the button. The green LED will go off.
To do a check of the battery and the
battery compartment
1. Clean the battery and the battery compartment with
a soft brush.
2. Make sure that the cooling slots and battery
connectors are clean.
3. Make sure that the battery is not damaged and there
are no other defects, such as cracks.
25