Husqvarna 436 Li Manuel D'utilisation page 16

4. Press on the lower part of the battery until you hear
a click sound.
CAUTION: If the battery does not move
into the battery holder easily, it is not
attached correctly into the battery holder.
5. Press and hold the start/stop button until the green
LED light comes on.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the chain speed and gives the
longest operation time from the battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
16
3. Press the SavE button again to disconnect the
function. The green LED goes out.
To stop the product
1. Press and hold the start/stop button on the keypad
until the green LED light comes off.
2. Pull out the battery and press the battery release
buttons to remove the battery from the battery
holder.
WARNING: Remove the battery when you
do not use or when you do not have full
vision of the product. This is to prevent
accidental start.
What is kickback?
WARNING: If a kickback occurs when the
saw chain rotates, it can cause serious
injuries or death to the operator. It is vital
that you understand the causes of kickback
and that you can prevent them with correct
working technique. If you are prepared you
decrease the risk.
481 - 001 - 22.01.2018