Lifting Pole; Transfer In And Out The Bed; Transport - Vermeiren Interval Mode D'emploi

Make sure that the bed's functions are not impaired when raising or lowering the side-rails,
for example when using wedges to ensure the patient's safety.
2.7

Lifting pole

The lifting pole can be mounted on either side of the headrest.
•
Insert the boom (1) as far as it will go into the relevant socket (2).
•
Let the arresting bolts (3) slide into the groove (4).
•
Pull the metal loop over the end of the upper frame (5) until the bolts engage one of
the three socket holes (6).
•
Also pull strap (7) into the metal loop and through the triangle (8); then fix its length.
Secure the strap.
2.8

Transfer in and out the bed

L L L L
CAUTION:
Risk of falling
manner, ask someone to assist you.
1. Position you as close as possible to the bed.
2. Check the brakes from the bed are in the on position.
3. Remove or fold down the side railings of the bed.
4. Transfer to/from the bed.
2.9

Transport

L L L L
WARNING:
Risk of injury – Make sure that the bed is attached properly in the car
or truck.
L L L L
WARNING:
Risk of injury – Transportation of the bed shall be only without the
patient.
To avoid damage when transported, the lifting pole should be detached. Unplug the power
cable and check that no cables hang near the floor.
Interval, Interval 120cm, Interval 140cm
1 = Lifting pole
2 = Boom socket
3 = Locking bolts
4 = Insert nut
5 = Upper frame boom
6 = Socket holes
7 = Strap
8 = Triangle
-
In case you can't perform the transfer in a safe
Page 11
2013-06