Publicité
Les langues disponibles
Les langues disponibles
Installing or removing driver bit or socket bit
004521
Use only bits that has inserting portion shown in the
figure.
To install the bit, insert the bit into the sleeve as far as it
will go.
1
2
011406
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as far as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
014996
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1. Bit
2. Sleeve
1. Groove
2. Hook
1
3. Screw
2
3
OPERATION
015158
CAUTION:
Never obstruct the air vents on the side of the tool
•
for cooling down oil unit and motor during
operation. Failure to do so may cause the tool
excessive heat and damage.
015153
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Standard bolt
N m
20
(ft lbs)
(15)
15
(11)
10
(7)
5
(4)
0
015300
9
1. Vent
1
M8(5/16")
M8(5/16")
M6(1/4")
M6(1/4")
1.0
2.0
Fastening time (S)
Publicité
