Télécharger Imprimer la page

EMAK EFCO DS2400H Manuel D'utilisation Et D'entretien page 26

Publicité

41
Italiano
ARRESTO MOTORE
ARRESTO MOTORE
Portare la leva acceleratore al minimo (B, Fig. 41) ed at ten de re alcuni
secondi per permettere il raff red da men to del motore.
Spegnere il motore, riportando l'interruttore di mas sa (A) nella
posizione di STOP.
UTILIZZO
USI VIETATI
- Spegnere il motore prima di appoggiare il tagliasiepi. Non
lasciare incustodito il tagliasiepi con il motore in funzione.
- Mantenere l'impugnatura pulita, asciutta e priva di tracce di
olio o miscela carburante.
- Non lavorare vicino a fili elettrici.
- Lavorare solo quando la visibilità e la luce sono sufficienti
per vedere chiaramente.
- Prestare particolare attenzione e allarme, quando si
indossano le protezione uditive, in quanto tali
apparecchiature possono limitare la capacità di ascoltare i
suoni indicanti i rischi (inviti, segnali, avvertimenti, ecc.)
- Siate estremamente cauti quando si lavora su pendii o
terreni sconnessi.
- Arrestare il tagliasiepi se la lama colpisce un oggetto
estraneo. Ispezionare il tagliasiepi e fare riparare le parti
danneggiate, se necessario.
- Tenere la lama pulita da sporcizia e sabbia. Anche un piccola
quantità di sporcizia rende rapidamente poco tagliente la
lama.
- Tagliando un ramo in tensione, fare attenzione a non farsi
cogliere di sorpresa dall'istantaneo allentamento della
tensione del legno.
26
English
STOPPING THE ENGINE
STOPPING THE ENGINE
Set the throttle lever to idle position (B, Fig. 41) and wait a few seconds
to let the engine cool off .
Turn off the engine, putting the ON/OFF switch (A) in the STOP position.
USE
PROHIBITED USE
- Shut off the engine before setting down the hedge trimmer.
Do not leave the engine running unattended.
- Keep the handles dry, clean and free of oil or fuel mixture.
- Do not work near electrical cables.
- Work only in conditions offering sufficient visibility and light
to see clearly.
- Be particularly cautious and alert when wearing ear
protectors, as these can restrict your ability to hear sounds
indicating danger (shouts, signals, warnings, etc.)
- Be extremely careful when working on slopes or uneven
surfaces.
- Stop the hedgetrimmer if the blade strikes a foreign object.
Inspect the hedgetrimmer and repair or replace parts as
necessary.
- Keep the blade clean from dirt and sand. Even a small
amount of dirt will quickly dull the blade.
- When cutting a branch that is under tension, be alert for
spring back so that you will not be struck when the tension
in the wood fibres is released.
Français
ARRET DU MOTEUR
ARRET DU MOTEUR
Portez le levier de l'accélérateur au régime du ralenti (B, Fig. 41) et
attendez quelques secondes afi n que le moteur se refroidisse.
Arrêtez le moteur en replaçant l'interrupteur de mas se (A) en position
STOP.
UTILISATION
USAGES INTERDITS
- Eteindrele moteur avant de poser le taille-haies. Ne laissez
pas le taille-haies tourner sans surveillance.
- Tenez vos mains au sec, propres et exemptes d'huile ou de
carburant.
- Ne vous approchez pas des fils électriques.
- Travaillez uniquement lorsque la visibilité et l'éclairage sont
suffisants.
- Soyez particulièrement attentif et vigilant lorsque vous
portez des casques de protection car de tels équipements
peuvent limiter la capacité d'entendre les signaux sonores
d'avertissement (alarmes, signaux d'avertissement, etc.)
- Soyez particulièrement prudents lorsque vous travaillez sur
les terrains en pente ou accidentés.
- Arrêter la machine si la lame atteint un corps étranger.
Contrôler à fond le taille-haie et, si nécessaire, faire réparer
les parties endommagées.
- S'assurer que la lame est toujours propre et éliminer la
saleté et le sable. Une toute petite quantité de saleté
compromet le tranchant de la lame.
- En coupant une haie, certaines branches pourraient être
enchevêtrées. Ne pas se laisser surprendre lorsque la
branche se dégage brusquement.

Publicité

loading

Ce manuel est également adapté pour:

Efco ds2400hlOleo-mac bc240hOleo-mac bc240hl