Making An Audio Recording; To Set For Automatic Standby Status (Auto Power Down); Restoring All The Settings To The Factory Default Settings - Pioneer ELITE A-20 Mode D'emploi

04 Operation

Making an audio recording

You can make an audio recording from any audio source connected to the amplifier.
SACD/CD player
Network audio player
/I STANDBY/ON
STANDBY PURE AUDIO Hi-Bit 32
iPod/USB 5V 2.1A
1 Select the source you want to record.
2 Start recording, then start playback of
the source component.
12
En
iPod dock, etc
Turntable
Tuner
NETWORK AUDIO PLAYER N-50
FUNCTION  
 
Playback
Recording 1
Audio recording component
(CD recorder, tape deck, etc.)

To set for automatic standby status (Auto Power Down)

When this condition is set, if no input signal is detected for 30 minutes, the unit will automatically enter standby
status.
1 If the unit's power is ON, hold the unit's front-panel DIRECT button and LOUDNESS
iPod
Music>
Extras>
Settings>
button depressed simultaneously for three seconds.
Shuffle Songs
Backlight
MENU
 

When this condition is set to ON, the STANDBY/APD indicator on the unit's front panel will light green. Press the
buttons again to disable the setting.
• The factory default setting is OFF.
Note
Depending on the device connected, excessive noise produced by the device may be interpreted as an audio
signal, thus preventing the Automatic Power-Down function from operating.

Restoring all the settings to the factory default settings

1 When power is in standby mode, hold the front-panel's DIRECT button and
SPEAKERS A button depressed simultaneously for five seconds.
2 Turn power ON to the unit.