Setting The Time; Setting The Timer; Childproof Lock; Oven - Junker JH23UC0 Série Notice D'utilisation

Use the + button to set a later end time.
6.
The setting is adopted after a few seconds.
The display shows the end time until the oven starts
operating.

Setting the time

Following a power cut or when the oven is used for the first
time, the symbol and three zeros flash in the display. Set the
0
time. The function selector must be switched off.

Setting the timer.

You can use the timer as a normal kitchen timer. It operates
independently of the oven. The timer has a specific signal. This
informs you when the timer or cooking time has elapsed. You
can also set the timer if the childproof lock is active.
Setting procedure
Press the timer button.
S
1.
The symbol flashes.
S
Use the + or - buttons to set the timer time.
2.
Default value for button + = 10 minutes
Default value for button - = 5 minutes
The timer starts after a few seconds. The
display. The time counts down in the display.
The time has elapsed
A signal sounds. Press the
goes out.

Childproof lock

Oven

To ensure that the oven cannot be switched on by children
when playing, a childproof lock is incorporated in the
appliance.
Switching the childproof lock on and off
The function selector must be switched off.
Press the key button repeatedly until the
C
appears in the display. This procedure takes approx.
4 seconds.
48
S symbol is lit in the
S timer button. The timer display
symbol
C
The cooking time has elapsed
A signal sounds. The oven switches off. Press the
twice and switch off the function selector.
Note: You can make changes as long as the symbol is
flashing. When the symbol lights up, the setting has been
adopted.
Setting procedure
Press the 0 clock button.
1.
12.00 appears and the
Use the + and - buttons to set the time.
2.
After a few seconds, the time is accepted. The
goes out.
Changing from summer to winter time.
Press the clock button twice and use the + or - buttons to
0
change the time.
Changing the alarm time
Press the timer button. Use the + or - buttons to change the
S
time.
Delete the setting
Press the S timer button. Press the - button until zeros appear
in the display.
The timer and the cooking time run down in synchronisation
The symbols are lit. The timer time counts down in the display.
Check the remaining cooking time,
x
of day:
Press the clock button repeatedly until the relevant symbol
0
is displayed.
The requested value appears in the display for several
seconds.
Deactivating: Press the C
symbol goes out.
Notes
You can set the timer and clock at any time.
■
If the childproof lock is active, it will be cancelled following a
■
power cut.
0
0 symbol flashes.
0
end time or
y
key button repeatedly until the
button
symbol
time
0
C