A 1.3 - Electrical Safety; A 1.4 - Transportation Safety; A 1.5 - Installation Safety - Beko GNE60520X Manuel D'utilisation

Safety and environment instructions
A
1.3 - Electrical safety
The product must be unplugged during
installation, maintenance, cleaning, repairing
and moving procedures.
If the power cable is damaged, it must be
replaced by a qualified person specified by
the manufacturer, authorised service agent or
importer in order to avoid potential dangers.
Do not squeeze the power cable under or
behind the product. Do not place heavy objects
on the power cable. Power cable must not be
bent excessively, pinched or get in contact with
any heat source.
Do not use extension cords, multi-sockets or
adapters to operate the product.
Portable multi-sockets or portable power
sources can overheat and cause fire. Therefore,
do not keep any multi-sockets behind or near
the product.
Plug must be easily accessible. If this is not
possible, the electrical installation to which the
product is connected must contain a device
(such as a fuse, switch, circuit breaker, etc.)
which conforms to the electrical regulations and
disconnects all poles from the grid.
Do not touch the power plug with wet hands.
Remove the plug from the socket by gripping
the plug and not the cable.
A
1.4 - Transportation safety
Product is heavy; do not move it alone.
Do not hold its door when moving the product.
Pay attention not to damage the cooling system
or the piping during transportation. If the piping
is damaged, do not operate the product and call
the authorised service agent.
A
1.5 - Installation safety
Call the authorised service agent for installation
of the product. To make the product ready for
use, check the information in the user manual
to make sure that the electricity and water
installations are suitable. If they are not, call a
qualified electrician and plumber to have the
necessary arrangements made. Otherwise,
there is the risk of electric shock, fire, problems
with the product, or injury!
Prior to installation, check if the product has
any defects on it. If the product is damaged, do
not have it installed.
Place the product on a clean, flat and solid
surface and balance it with adjustable feet.
Otherwise, the product may tip over and cause
injuries.
The installation location must be dry and
well ventilated. Do not place carpets, rugs or
similar covers under the product. Insufficient
ventilation causes the risk of fire!
Do not cover or block the ventilation openings.
Otherwise, power consumption increases and
your product may get damaged.
Product must not be connected to supply
systems such as solar power supplies.
Otherwise, your product may get damaged due
to sudden voltage changes!
The more refrigerant a refrigerator contains,
the larger the installation location must be. If
the installation location is too small, flammable
refrigerant and air mixture will accumulate in
cases of refrigerant leakage in cooling system.
The required space for each 8 gr of refrigerant
is 1 m³ minimum. The amount of refrigerant in
your product is indicated on the Type Label.
Product must not be installed in places
exposed to direct sunlight and it must be
kept away from heat sources such as hobs,
radiators, etc.
If it is inevitable to install the product close to
a heat source, a suitable insulation plate must
4 / 34 EN
Refrigerator / User Manual