Starting Operation - EuroLite Foam 1200 Cannon Mode D'emploi

Before filling the device disconnect from mains. Never fill in any hot liquids.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Store dry!
Always drain the tank and please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

STARTING OPERATION

Install the device on a plane surface. The cannon must be installed on the stand first.
Connect the pump with the cannon using the enclosed fluid hose.
Fill some foam fluid into the liquid container so that the pump does not run dry.
Insert the pump's fluid hose into the liquid container.
Only use quality foam fluids available at your dealer. We recommend high-quality Eurolite Foam fluids (e. g.
EUROLITE Foam Fluid, 5 l). You must not use substances that are classified as "dangerous working
material" or "inflammable fluids".
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.
Caution! Ensure a minimum distance between foam machine and audience of min. 2m. Never direct the
foam output nozzle to the face or the eyes of people.
Installation
Install the device out of the public area. Please consider that liquid may be spilt during operation around the
device. The resulting slippery surface can cause accidents. Keep a minimum distance of 20 cm around and
above the device.
Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15°.
This device is only constructed for a standing installation. If the device is to be installed overhead, the
following safety instructions are binding:
Please consider the
installation! The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
DANGER TO LIFE!
EN 60335-1:1996 a nd the respective national norms during the
11/23 00063281.DOC, Version 1.0