Bosch GWX Professional 18V-10 PC Notice Originale page 28

28 | English
User interface (see figure D)
The user interface (5) is used to preselect the speed and to
indicate the status of the power tool.
Material Application
Metal Brushing, removing rust
Stainless steel Grinding
Metal Rough grinding
Metal Cutting
Stone Cutting
The values specified for speed levels are guide values.
The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
Status indications
Battery charge indicator Meaning/cause
(user interface) (29)
Green Battery charged
Yellow Battery almost empty
Red Battery empty
Overload protection indic- Meaning/cause
ator (33)
Yellow Critical temperature has been reached (mo-
tor, electronics, battery)
Red Power tool is overheated and will switch off
Power tool status indicator Meaning/cause
(32)
Green Status OK
Yellow Critical temperature has been reached or bat-
tery is almost empty
Illuminated red Power tool is overheated or battery is empty
Flashing red Kickback shutdown, restart protection or im-
pact shutdown has been triggered
Flashing blue Power tool is connected to a mobile device or
settings are being transferred
Connectivity functions
In conjunction with the GCY 30-4 Bluetooth
Module, the following connectivity functions are available for
the power tool:
– Registration and personalisation
– Status check, output of warning messages
1 609 92A 4F8 | (10.01.2019)
Speed preselection (GWX 18V-10 PSC)
You can use the button for speed preselection (31) to
preselect the required speed, even during operation. The in-
formation in the table below describes the recommended
values.
Application tool Speed preselection
level
Cup brush 1
Fibre disc 2
Grinding disc 3
Cutting disc 3
Diamond cutting disc and 3
cutting guide (cutting
stone is permitted only
with a cutting guide)
tool. Accessories running faster than their rated speed
can break and fly apart.
– General information and settings
®
Low Energy – Management
Read the corresponding operating instructions for informa-
tion about the GCY 30-4 Bluetooth
GWX 18V-10 PSC
-1
[min ]
4500
6000
9000
9000
9000
Solution
–
Replace or charge battery soon
Replace or charge battery
Solution
Run the power tool at no load and allow it to
cool down
Leave the power tool to cool down
Solution
–
Run the power tool at no load and allow it to
cool down, or replace or charge the battery
soon
Allow the power tool to cool down, or replace
or charge the battery
Turn the power tool off and on again
–
®
Low Energy Module.
Bosch Power Tools