Cleaning The Pre-Filter; Cleaning The Fine Dust Filter Manually - Miele Blizzard CX1 Electro Mode D'emploi

en
Fault resolution

Always disconnect the vacuum
cleaner from the power supply be-
fore attempting to rectify a fault.
Switch off at the wall socket and un-
plug it.
Cleaning the pre-filter (dia. 30 + 31)
The pre-filter is located at the rear of the
dust container.
This should be cleaned if it is obviously
dirty.
 Remove the dust container.
 Release the handle of the pre-filter
and remove the pre-filter.
 Rinse the pre-filter under cold running
water.

Do not use washing-up liquid.
Do not use any sharp or pointed ob-
jects.
Dry the pre-filter carefully.
 Replace the dry filter in the dust con-
tainer and lock the handle.
 Replace the dust container in the va-
cuum cleaner.
Cleaning the fine dust filter
manually (dia. 32 - 37)
Allow a drying time of 24 hours.
 Remove the dust container.
 Release the fine dust container from
the vacuum cleaner in the direction of
the arrow and remove it.
 Run a little water into the opening at
the top of the fine dust container.
42
 Gently shake the fine dust container
back and forth.
This will rinse out the dust.
 Shake to empty the water out.
 Turn the upper part in the direction of
the arrow so that the marking is
pointing to the  symbol.
This releases the upper part.
 Carefully lift the fine dust filter up-
wards and out of the fine dust con-
tainer.
 Rinse the outside of the fine dust filter
under cold running water.

Do not clean the inside of the
fine dust filter.
Do not use washing-up liquid.
Do not use any sharp or pointed ob-
jects and do not brush the fine dust
filter.
After cleaning, allow the fine dust fil-
ter to dry for a minimum of 24 hours.
 Clean the fine dust filter container
with water and mild washing-up li-
quid.
 Dry the fine dust filter container thor-
oughly.
 Insert the dry fine dust filter into the
dry fine dust container so that the
marking is pointing to the  symbol.
 Turn the upper part in the direction of
the arrow so that the marking is
pointing to the  symbol.
The upper part is locked.
 Replace the fine dust container in the
vacuum cleaner and lock it into place.