Miele Blizzard CX1 Electro Mode D'emploi page 29

– Fine dust filter: do not clean the inside of the fine dust filter. Rinse
the outside under running cold water. Do not use washing-up li-
quid. Do not use any sharp or pointed objects and do not brush
the fine dust filter. After cleaning, leave the fine dust filter to dry
for a minimum of 24 hours before placing it back in the fine dust
container.
– Pre-filter / filter frame: rinse under running cold water. Do not use
washing-up liquid. Do not use any sharp or pointed objects. Dry
thoroughly after cleaning.
Correct use

Do not use the vacuum cleaner without the dust container, pre-fil-
ter, fine dust container and fine dust filter fitted.

Do not vacuum up anything which has been burning or is still
glowing e.g. cigarettes, ashes or coal, whether glowing or apparently
extinguished.

Do not use the vacuum cleaner to vacuum up any water, liquid or
damp dirt. Wait until any freshly cleaned or shampooed rugs or car-
pets are completely dry before attempting to vacuum.

Do not use the vacuum cleaner to vacuum toner dust. Toner, such
as that used in printers and photocopiers, can conduct electricity.

Do not vacuum up any inflammable or combustible liquids or
gases and do not vacuum in areas where such substances are
stored.

Do not vacuum at head height and do not let the suction get any-
where near a person's head.
Accessories

To avoid the risk of injury when vacuuming with a Miele Electro-
brush or Turbobrush, do not touch the rotating roller brush.
en - Warning and Safety instructions
29