Handing Over; Environment And Recycling - AEG HE 181 Notice D'utilisation Et De Montage

2.4.2 Wall mounting
a. Transfer the four mounting points to the wall using the drilling template (see page 11) and drill
the mounting holes. Note the length and position of the power supply lead.
b. Screw the fixing screws into the wall.
c. Draw the power supply lead through the cable grommet (5) at the rear panel of the dryer.
d. Hang the unit to the wall, using the keyholes on the rear of the unit.
e. Screw the appliance (2) to the wall.
2.4.3 Electrical Connection
HE 181: The dryer is designed only for permanent connection to 220 V – 240 V~ 50 Hz alternating
current.
HE 260 T / HE 260 TM: The dryer is designed only for permanent connection to 220 V – 240 V~
50/60 Hz alternating current.
Please observe the rating place!
The PVC-angle (8) piece fixed in the metalcase of the HE 260 TM provides insulation for the
electric connection.
The voltage shown on the rating plate must agree with the supply voltage. Cable should be
correctly sized in accordance with the loading of the appliance.
The power supply cable must not be located in the vicinity of the fan motor.
The maximum lenght of the cable must not exceed 20 cm.
2.4.4 Mounting the front cover
HE 181, HE 260 T
a. Hook the button of the front cover onto the front of the casing, and push top of front cover
towards the wall.
b. Push the locking bolt upwards to secure the case.
c. Fix securing screws.
HE 260 TM
a. Push the outer casing over the body of the unit until it touches the wall. Ensure that the outer
casing is square to the wall.
b. To lock the outer casing in position, lift the casing slightly from the front, and push up the
locking bolt.
c. Fix securing screw.
2.5

Handing over

Hand over the operating and installation instructions to the user.
Explain the functions of the unit and ensure that the user pays particular attention to the safety
instructions.
3. Guarantee
For guarantee please refer to the respective terms and conditions of supply for your country.
The installation, electrical connection and first operation of this appliance should be carried
out by a qualified installer.
The company does not accept liability for failure of any goods supplied which are not
installed in accordance with the manufacturer's instructions.
3.1

Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the
national regulations for waste processing.
3.1.1 Recycling of obsolete appliances
Appliances with this label must not be disposed off with the general waste. They must be
collected separately and disposed off according to local regulations.
2
3
4
For the Fitter
15