For The User; Description Of The Unit - AEG HE 181 Notice D'utilisation Et De Montage

1. Operation instructions
1.1

Description of the unit

The automatically operating AEG HE 181, HE 260 T and HE 260 TM hand dryers are fitted with a
proximity switch which activates the fan when your hands are brought towards it, (approximately
60 - 120 mm below the warm air exit grille). The dryer automatically switches off approximately
3 seconds after the hands have moved away from the sensor.
The casing design does not allow cigarettes or drinks etc to be placed on top, causing a hazard. To
retain this feature, when assembling ensure that there are no gaps between the wall and the unit.
In addition, the HE 260 TM is protected against damage by the cast aluminium casing.
1.2 Operation
In order to save energy and shorten the drying time, vigorously shake wet hands over the
washbasin, then hold your hands beneath the air exit grille rubbing them together in the warm
airstream.
1.3 Safety notes
During operation, temperatures of over 90 °C can occur at the warm-air exit grille. Due to
the risk of overheating this should not be covered.
In the event of overheating the temperature safety cut out switches off the heating element and
the fan continues to run in a cooling mode. The heating element switches back on after
approximately two minutes.
Ensure that the air inlet grilles on the underside and rear of the dryer are always kept open.
Trouble-free function and operational safety can only be guaranteed if the original AEG
accessories and spare parts are used.
1.4 Care
When cleaning the casing, only use a soft cloth, with a mild detergent if necessary, and repolish
with a soft cloth. Do not spray the dryer with water or use any abrasive or caustic cleaning agents.
1.5 Trouble-shooting
Like all proximity switches, the operation of the sensor is impaired if it is covered. If this happens
the hand dryer automatically switches off after 3 seconds preventing it from running continuously.
In the event of an operating failure, check that the sensor has not been covered. After the removal
of any objects the dryer should function as normal.

For the User

13