Weighing With Taring; Weighing With Tolerance Range - KERN KFE-TM Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.5 Weighing with taring

 Deposit weighing vessel. After successful stop check press the
display and indicator
The weight of the container is now internally saved.
 Weigh the material, the net weight will be indicated.
 After removing the weighing container, the weight of the weighing container
appears as negative display.
 The taring process can be repeated any number of times, e.g. when adding
several components for a mixture (adding). The limit is reached when the whole
weighing range is exhausted.
 To change between gross weight and net weight, press
 To delete the tare value, remove load from weighing plate and press
7.6

Weighing with tolerance range

You can set an upper or lower limit when weighing with tolerance range and thus
ensure that the weighed load remains exactly within the set limits.
During tolerance controls such as dispensing, portioning or sorting the unit will
indicate whether a value exceeds or falls short of limits with an optical [LO, OK, HI]
as well as an audio signal according to the setting in the menu block "F4
oFF_BEEP"; see chapter 8.2.
Selectable mode
bp 1
bp 2
bp 3
KFE-TM-BA_IA-e-1614
NE T
appear.
Description
Acoustic signal switched off, only optical signal active
[LO], [OK] or [HI]
If load is within tolerance range, [ok] will be displayed
and audio signal will be sounded.
If the load is beyond the tolerance range [ok] will be
shown and the audio signal will sound.
button. Zero
.
.
19

Publicité

Table des Matières
loading

Table des Matières