Bosch GSB 14,4-2-LI Plus Notice Originale page 11

OBJ_BUCH-2389-002.book Page 11 Friday, April 24, 2015 9:26 AM
Symbol Meaning
Recommended chargers for wireless
charging batteries
Delivery Scope
Cordless screwdriver/Combination cordless drill.
Battery, application tools and other accessories shown or de-
scribed are not part of the standard delivery scope.
A complete overview of accessories can be found in our ac-
cessories program.
Intended Use
The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal, ceramics and plastic.
GSB machines are additionally intended for impact drilling in
bricks, brickwork and masonry.
The light of this power tool is intended to illuminate the power
tool's direct area of working operation and is not suitable for
household room illumination.
Technical Data
The technical data of the machine are listed in the table on
page 164.
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with all rele-
vant provisions of the directives 2009/125/EC (Regulation
1194/2012), 2011/65/EU, until 19 April 2016:
2004/108/EC, from 20 April 2016 on: 2014/30/EU,
2006/42/EC including their amendments and complies with
the following standards: EN 60745-1, EN 60745-2-1,
EN 60745-2-2.
Mounting and Operation
Action
Removing the battery
Inserting the battery
Mounting application tools
Reversing the rotational direction
Setting the torque
Selecting the drilling position
Setting the operating mode
Gear selection, mechanical
Mounting/dismounting the belt clip
Mounting/dismounting the bit holder
Switching On and Off
Selecting Accessories
Bosch Power Tools
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen, GERMANY
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
20.03.2015
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 164.
Sound emission values determined according to EN 60745-2-1.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745-2-1.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure
1
2
3
4
5
6
7
8
9
10
11
–
English | 11
Page
165
165
165
166
166
167
167
167
168
168
168
169
1 609 92A 1CM | (24.4.15)